Posted: Mon May 17, 2010 5:36 am
Good thinking Noly..
I'm recommending the EDT blocks now AFTER doing justice to your big barbell lifts. Let's look at the EDT blocks (first 5 workouts) in the Feast template again:
EDT BLOCK - sets performed back to back
Incline DB presses
Tbar rows
EDT BLOCK - Sets performed back to back
Romanian Deadlifts
Leg Sled
An EDT PR "zone" works as follows. Let's look at incline dumbell pressess and Tbar Rows, as an example:
Barbell curls
Lying tricep extensions on a flat bench with barbell
You select a weight that's your 10 rep max. Let's say that's 100lbs on the barbell curl and on tricep extensions it's also 100lbs
START OF SET #1: 12 noon. The total time it takes to do a superset of each is exactty one minute.
On set #1, you get 6 reps with the barbell curl (note.. NOT going to failure) and immediately go into the lying tricep extensions, again achieving 6 reps.
Rest exactly 2 minutes
On set 2, same drill and again you achieve 6 reps on each
Rest exactly 2 minutes
On set 3, same drill but now you get just 5 reps
Rest exactly 2 minutes
On set 4, you again achieve 5 reps apiece
Rest exactly 2 minutes
On set 5, you achieve just 3 reps on each exercise
Rest exactly 2 minutes
On your final set, you rep out both exercises and get 3 reps apiece..
Total workout time: 16 minutes. You tally up the total amount of reps for each and there's your baseline: You achieved 56 reps in a total of 16 minutes.
Your challenge the next time out is to get more reps with the same weight. Once you are able to do 20% more (68 reps) within the same time period, you up the weight 5% to 105lbs on each exercise.
Does that help?
KEY POINTS
- Alternate antagonistic muscle exercises in jump set fahion
- Staley's generally uses 15-20 minutes, (called a PR Zones).
- You perform two PR Zones per workout.
- Your target weight is one that you can do 10 clean reps with.
- You will begin with alternating sets of 5 or 6 reps.
- As you tire, you may reduce set reps to 4 then 2 and end with singles.
- Your goal is to do as many reps with good form as possible in the PR Zone.
- Do not work to, or near failure in the early sets.
- You may reach failure at the end as you try to beat your previous record.
- Once able to do 20% more reps than your prior workout, increase load 5% and begin again.
I'm recommending the EDT blocks now AFTER doing justice to your big barbell lifts. Let's look at the EDT blocks (first 5 workouts) in the Feast template again:
EDT BLOCK - sets performed back to back
Incline DB presses
Tbar rows
EDT BLOCK - Sets performed back to back
Romanian Deadlifts
Leg Sled
An EDT PR "zone" works as follows. Let's look at incline dumbell pressess and Tbar Rows, as an example:
Barbell curls
Lying tricep extensions on a flat bench with barbell
You select a weight that's your 10 rep max. Let's say that's 100lbs on the barbell curl and on tricep extensions it's also 100lbs
START OF SET #1: 12 noon. The total time it takes to do a superset of each is exactty one minute.
On set #1, you get 6 reps with the barbell curl (note.. NOT going to failure) and immediately go into the lying tricep extensions, again achieving 6 reps.
Rest exactly 2 minutes
On set 2, same drill and again you achieve 6 reps on each
Rest exactly 2 minutes
On set 3, same drill but now you get just 5 reps
Rest exactly 2 minutes
On set 4, you again achieve 5 reps apiece
Rest exactly 2 minutes
On set 5, you achieve just 3 reps on each exercise
Rest exactly 2 minutes
On your final set, you rep out both exercises and get 3 reps apiece..
Total workout time: 16 minutes. You tally up the total amount of reps for each and there's your baseline: You achieved 56 reps in a total of 16 minutes.
Your challenge the next time out is to get more reps with the same weight. Once you are able to do 20% more (68 reps) within the same time period, you up the weight 5% to 105lbs on each exercise.
Does that help?
KEY POINTS
- Alternate antagonistic muscle exercises in jump set fahion
- Staley's generally uses 15-20 minutes, (called a PR Zones).
- You perform two PR Zones per workout.
- Your target weight is one that you can do 10 clean reps with.
- You will begin with alternating sets of 5 or 6 reps.
- As you tire, you may reduce set reps to 4 then 2 and end with singles.
- Your goal is to do as many reps with good form as possible in the PR Zone.
- Do not work to, or near failure in the early sets.
- You may reach failure at the end as you try to beat your previous record.
- Once able to do 20% more reps than your prior workout, increase load 5% and begin again.